7-38
Figure 7-32 Separate Tilt Leg from Leg Support
Tilt Leg
4.
Push the two stopper tabs through the slots to separate the tilt leg
from the leg support.
5.
Lay the tilt leg and the leg support flat to expose APR-L UNIT
compartment.
6.
Carefully pry loose the knockout covering the bottom option interface
(refer to
Figure 7-33 Bottom Option Interface
Figure 7-33 Bottom Option Interface Knockout
Knockout
7.
Using the exposed Bottom Option Interface as a guide, install the
APR-L UNIT in the bottom of the DTL/DTZ multiline terminal. Push
down until left and right tabs are seated (Refer to
APR-L UNIT on page
Knockout).
7-39).
Installing SV9100 Optional Equipment
Issue 2.0
Stoppers
Bottom Option
Interface
Figure 7-34 Install