Figure 7-22 Nec Terminal Connection To An Ieee 802.3Af Poe Switch - NEC Univerge SV9100 System Hardware Manual

Issue 2.0

Figure 7-22 NEC Terminal Connection to an IEEE 802.3af PoE Switch

SV9100 System Hardware Manual
3. Connect the NEC VoIP telephone to the TEL connector on the ILPA-R
adapter with the LAN cable provided with the adapter.
If a customer-provided cable is used, the total length from the

switch to the telephone should be less than 328 feet.
The adapter can be positioned either closer to the multiline

terminal or switch – it does not matter.
4. Connect a crossover LAN cable to the LAN connector on the ILPA-R
adapter. Plug the opposite end into the switch which is to provide
power to the telephone. Refer to
Connection to an IEEE 802.3af PoE
If a straight-through cable is used, NIC Auto Detection must be

enabled in Programs 10-12-05 (GCD-CP10), 84-05-02
(VOIPU) or 85-01-03 (SHUBU).
Figure 7-22 NEC Terminal
Switch.
7-29