Figure 3-53 Wall Mount Positioning For 9.5" Base/Expansion Chassis - NEC Univerge SV9100 System Hardware Manual

4.2
3-46
Wall Mounting the 9.5" Gateway (CHS2UG GW) and Base
(CHS2UG B) Chassis
When wall mounting the chassis, ensure the wall can support the weight of the
chassis and (25 lbs per system chassis ---- including blades, cords, power supply,
etc.). The chassis is secured to the wall with a wall mount bracket.
Optional wall mounting procedures exist for the 9.5" chassis. Option 1: the
mounting bracket is secured to the wall and the chassis is attached to the bracket.
Option 2 attaches the bracket to the 9.5" chassis and then, using the key-holes as
a guide, the assembled unit slides over screws secured to the wall using the
template shown in
To wall mount the Base and Expansion chassis as a combined unit, refer to

4.2.1.1 Wall Mounting the 9.5" Base (CHS2UG B) and Expansion (CHS2UG E)
Chassis on page 3-54.
To wall mount the CHS2UG B with the external battery installed, refer to

4.2.2.2 Wall Mounting the CHS2UG B with the CHS2UG B Small Batt Box
on page 3-63.
4.2.1 Option 1 – Wall Mounting the 9.5 inch Base
Chassis
When mounted, clearance between the wall and the CHS2UG B/

CHS2UG E chassis is approximately 1.7 in (43mm) due to height of
the wall mounting bracket.
The chassis must be mounted horizontally with the slot (front) side on

the right.

Figure 3-53 Wall Mount Positioning for 9.5" Base/Expansion Chassis

Due to EXIFU cable length, a maximum of 2 (1 CHS2UG B and 1 CHS2UG E)

chassis can be wall mounted. If additional chassis are to be mounted, consider
using the floor mounting procedure.
Issue 2.0
( )
CHS2UG B
Installing the SV9100 Chassis