11.3.2 Installing The Ada-L Unit; Figure 7-24 Separate Tilt Leg From Leg Support - NEC Univerge SV9100 System Hardware Manual

7-32

11.3.2 Installing the ADA-L UNIT

Perform the following steps to connect the ADA-L UNIT to the Bottom
Option Interface located underneath the DTL/DTZ/ITL/ITZ multiline
terminal.
IMPORTANT
WARNING
1. Unplug the line cord from the multiline terminal.
2. Turn the DTL/DTZ/ITL/ITZ multiline terminal upside down.
3. Lower the tilt leg to the first position (refer to
Leg from Leg

Figure 7-24 Separate Tilt Leg from Leg Support

Tilt Leg
4. Push the two stopper tabs through the slots to separate the tilt leg
from the leg support.
5. Lay the tilt leg and the leg support flat to expose ADA-L UNIT
compartment.
6. Carefully pry loose the knockout covering the bottom option interface
(refer to
7-33).
Only ONE ADA-L UNIT can be installed at a time.
To prevent possible damage to the ADA-L UNIT or the DTL/
DTZ/ITL/ITZ multiline terminal during installation or
removal, disconnect the line cord/LAN cable and the AC/
DC adapter from the DTL/ITL multiline terminal.
Support).
Figure 7-25 Bottom Option Interface Knockout on page
Installing SV9100 Optional Equipment
Issue 2.0
Figure 7-24 Separate Tilt
Stoppers