Issue 2.0
SV9100 System Hardware Manual
7.
Connect the two-conductor station cable from the CN5 connectors in the
PGDAD to the external relay/external page.
Figure 7-13 PGDAD Cable Connection
TIP
The PGDAD provides amplifiers for each page output port
(for a maximum of +8 dBM, 600 ohms at 1KHz). No
additional page amplification is provided by the PGDAD but,
if required, an external page amplifier can be used for
additional amplification.
The page output of the GCD-CP10 does not provide
amplification (for a maximum output of -3 dBm, 600 ohms at
1KHz). If the paging volume is not satisfactory using the
AUX1 or AUX2 connector on the GCD-CP10, the PGDAD
should be used instead.
7-15