Figure 3-103 Rack Mount 19" Chs2Ug - NEC Univerge SV9100 System Hardware Manual

Hide thumbs Also See for Univerge SV9100:

Table of Contents

SV9100 System Hardware Manual

Repeat for additional chassis mounting.

Figure 3-102 Rack Mount Bracket Installed 19" CHS2UG

Carefully slide the chassis into desired location in the rack. Make sure the

hooks on the mounting bracket are inserted into the back of the chassis,

securing it in place. Note that the cabling is run through the front of the rack

for ease of access.

Each CHS2UG chassis will require approximately 3.5" of height

within the rack.

Secure the brackets to the rack using the screws supplied.

Repeat for additional chassis mounting.

Figure 3-103 Rack Mount 19" CHS2UG

Single CHS2UG Rack Mount

Connect the ground wire to all chassis. Refer to

19" Chassis on page 3-19

Single CHS2UG Rack Mount with

Three Expansion Chassis

3.3.3 Install Grounding on

for complete details on grounding the system.