Ip Address; Changing Controller Ip Address - Epson RC620 CU Manual

Setup & Operation 6. LAN (Ethernet Communication) Port

6.2 IP Address

Set the proper IP address or subnet mask depending on the Controller configuration to use
the LAN port.
Use an address from the following Private Address List in the closed network environment
such as P2P or production line. Also, make sure the address is not redundantly assigned
inside the closed network.
In other cases, check with the network administrator.
172.16.0.1
192.168.0.1
Configuration of the controller at shipment:
LAN-1 port
LAN-2 port
6.3 Changing IP Address
6.3.1 LAN-1 port
Change the IP address of LAN-1 port.
(1) Select the EPSON RC+ 6.0 menu | Setup | Controller to display the [Setup Controller]
(2) Enter the proper IP address and subnet mask and click the <Apply> button.
(3) Click the <Close> button. The Controller reboots automatically.
(4) Connect the Ethernet cable to the Controller LAN-1 port.

NOTE
LAN-1 port cannot automatically acquire the IP address (not support DHCP).
42
Private Address List
10.0.0.1 to 10.255.255.254
to 172.31.255.254
to 192.168.255.254
IP Address
IP Mask
IP Gateway
* LAN-1 port cannot automatically acquire the IP address (not support DHCP).
This port can acquire the IP address automatically.
dialog.
IP address configuration is completed and the Controller reboot dialog disappears.
: 192.168.0.1
: 255.255.255.0
: 0.0.0.0
RC620 Rev.8