Installing The Battery - HP PageWriter XL M1705B Service Manual

Installing the Battery
Note .I
Q?
Warning
Note
:I
+&
This procedure describes installing the battery for the first time.
If you are replacing a battery, refer to the battery replacement
procedure in Chapter 7, "Removal and Replacement."
The cardiograph is primarily a battery-powered instrument. It will
not operate without the battery, even if it is plugged into AC power.
Use only HP battery assembly M1721A.
The battery is relatively heavy for its size. Support the battery from
underneath as you install it to prevent it slipping and possibly causing
injury.
To install the battery:
1. Open the cardiograph's battery compartment by loosening the
two thumbscrews on the back of the cardiograph (as shown in
Figure 2-G), and pulling the battery holder out.
Figure 2-6. Installing the Battery.
A. Battery door
B. Thumbscrews
Figure 2-6 shows the M1700A; other models are similar.
2. Install the battery
on
the battery holder. Make sure the tab on
the door fits into the slot on the battery (refer to Figure 2-7).
Installation and Configuration 2-l 1