Fitting The Battery Holder Tab Into The Battery Slot - HP PageWriter XL M1705B Service Manual

Figure 2-7. Fitting the Battery Holder Tab Into the Battery Slot.
A. Battery slot
3. Gently slide the battery and holder into the battery compartment
until completely seated.
4. Finger-tighten the thumbscrews on the battery holder.
5. Connect the power cord to the cardiograph, then plug the cord
into an AC outlet.
6. Turn
on
the AC switch on the back of the cardiograph. The green
AC indicator on the front panel should light up.
7. Press the (On-Standby) switch to turn on the cardiograph. The
cardiograph will begin its power-on sequence. The M1700A and
M1701A cardiographs will briefly display PageWriter XLi or
PageWriter XLs in the keyboard display, then display the code
6503 (this code indicates that the software is not yet installed
and there is no System disk in the disk drive). At the same time,
all of the control panel indicators will light up, including the
red low-battery indicator and the green charge indicators. The
M1702A cardiograph will display a line of asterisks for about two
minutes as it loads software from its built-in ROM. During this
time, it may prompt for language and line frequency.
S. Press ion-Standby) again to place the cardiograph in Standby. When
the cardiograph is in Standby, it is not operational, but it is
powered.
,r7
Note
:'
u
To ensure full battery capacity, charge the battery for 24 hours
following its installation in the cardiograph.
,r7
2-12 Installation and Configuration