Loading The Paper - HP PageWriter XL M1705B Service Manual

Note .I
$
The battery level indicators function only after software is installed.
,rl
To verify battery capacity, turn on the unit while the cardiograph is
connected to AC power and the AC switch is on. The cardiograph
must be connected to AC power when verifying battery capacity.
Once the software is installed, it does not need to be reinstalled
unless the cardiograph loses battery power or has a system failure, or
if you want to load upgraded or custom-configured software.
Installing the Software
The software for the M1702A is stored in ROM and loaded into
on the M1702A
memory automatically when the cardiograph is turned on for the
first time, or after the battery has been replaced. This process takes
about two minutes. During this time, you will be prompted for
language and line frequency.
Loading the Paper
The cardiograph uses continuous-feed thermal paper, HP part
number M1707A (A size) or M1709A (A4 size). To load the paper:
1.
2.
3.
4.
5.
6.
Release the printer door latch on the left side of the cardiograph
and slide the printer door to the left.
Remove the paper from its packaging but do not remove or
discard the cardboard backing.
Slide the paper stack (cardboard down) into the compartment.
The paper should feed grid-side up over the top panel of the
printer door.
Pull the free end of the paper back to the far end (latch end) of
the top panel (see Figure 2-S).
Slide the printer door back into place making sure that it latches.
Press (Page-) to advance the paper to the beginning of the
next page.
2-14 Installation and Configuration