4.22 Parameter Clear/ All Parameter Clear - Mitsubishi Electric FR-E700EX Instruction Manual

4.22 Parameter clear/ All parameter clear

POINT
 Set "1" in Pr.CL Parameter clear, ALLC All parameter clear to initialize all parameters. (Parameters are not cleared
when "1" is set in Pr.77 Parameter write selection.)
 Refer to the extended parameter list on page 52 for parameters cleared with this operation.
Operation
1. Screen at power-ON
The monitor display appears.
2.
Press to choose the PU operation mode.
3.
Press to choose the parameter setting mode.
4.
Turn until
5.
Press to read the currently set value.
" "(initial value) appears.
6.
Turn to change it to the set value "
7.
Press to set.
 Turn
 Press
 Press
Setting
0 Not executed.
Set parameters back to the initial values. (Parameter clear sets back all parameters except
1 calibration parameters, terminal function selection parameters to the initial values.) Refer to the
parameter list on page 52 for availability of parameter clear and all parameter clear.
REMARKS
and
The drive unit is not in the PU operation mode.
PU connector or USB connector is used.
Remove the PU cable and the USB cable, and carry out the operation from step 2 again.
 Stop the drive unit. Parameter clear is unavailable when the drive unit is running, and will cause the write disable error.
( ) appears.
".
to read another parameter.
to show the setting again.
twice to show the next parameter.
Description
are displayed alternately ... Why?
Parameter clear/ All parameter clear
Display
PU indicator is ON.
PRM indicator is ON.
(The parameter number read previously appears.)
Parameter clear
All parameter clear
Parameter clear
All parameter clear
Flicker... Parameter setting complete!!
4
261