Conveyor Set-Up For Print Operation - Yamaha YSP10 Service Information

13.12.2. Conveyor set-up for print operation

Note
See "YSP10 User's Manual" for the information of conveyor set-up procedures.
Check that a matrix plate is set on the PU plate. If not, set a matrix plate.
Check the board size setting of the CUK-B0301 board used for print feedback adjustment.
Make sure that "CALIB_B0301_PRINTER" is loaded.
The CUK-B0301 board size:
Check that the edge clamp pressure is 0.169MPa.
Set the conveyor width for print feedback adjustment: 250mm
Press the [Sw. Prod. Position] button.
Set backup pins on the conveyor so that the CUK-B0301 board can be clamped on
the conveyor evenly.
Prepare for printing solder on the CUK-B0301 board including setups of the mask,
cleaner, squeegee and solder paste.
Board Size X (mm)
Board Size Y (mm)
Board Size Height (mm)
SI1906002E-001=YSP10 installation and adjustment procedures
104/120
For Service Engineers
Service Information
330.000
250.000
1.600