Yamaha YSP10 Service Information page 86

Press the [Move Setting Pos.] button.
Check that the PU-axis raised.
When the PU-axis does not raise, press [Push-up] button on [Units] > [Conveyor] screen and input
"4mm" for its height.
Press the Emergency Stop button.
Set the adjustment tool on the machine.
Open the machine front door and set some backup pins around center of the front conveyor to set the
adjustment tool.
Print table top
Backup pins
SI1906002E-001=YSP10 installation and adjustment procedures
86/120
For Service Engineers
Service Information
Set the tool with its light
gray side directed inside
of machine.