Connect Power Cables To The Ce Transformer - Yamaha YSP10 Service Information

12.4. Connect power cables to the CE transformer

If the optional CE transformer is not used, skip this section.
Warning
Electrical wiring work shall be performed by a certified electrician.
Turn off the mains power supply.
Turn off the circuit breaker of the mains power supply or equivalent to shut off power to the CE
transformer's power cable.
Note
Turn off the circuit breaker of the mains power supply or equivalent to shut off power to the CE
transformer's power cable.
Remove the front lower cover of the CE transformer.
Remove 3 screws using a
Phillips screwdriver.
Breaker on
Be sure to turn off the mains power
power
before starting service work.
distribution
panel
turned OFF
Not powered
SI1906002E-001=YSP10 installation and adjustment procedures
54/120
For Service Engineers
Service Information
Cover
Remove the cover.