Yamaha YSP10 Service Information page 34

Press the [Width] button.
Press the [Width] button at the lower left part of the screen.
Input the line alignment jig width to the [Target Width] box.
Input "170" or "250" in accordance with the line alignment jig to be used.
L-shaped line alignment jig or glass frame of board
Press the [OK] button to perform the conveyor width adjustment.
Caution
After setting the conveyor width, DO NOT apply force on the conveyor frame. Otherwise the
conveyor width may change.
SI1906002E-001=YSP10 installation and adjustment procedures
34/120
For Service Engineers
Service Information
Offset line alignment jig
Press