Yamaha YSP10 Service Information page 41

Check the fitting of the line alignment jigs.
Refer to "1.2 Line alignment jig arrangement" through "1.2.3 How to use the offset line alignment jig set"
on page 5 through 7 for how to use line alignment jigs.
Conveyor to conveyor
Distance between machines
Note
When the lock nut is fastened at "9.4 Fasten the levelling bolts" below, the machine height will be
raised by the amount of leveling bolt backlash (approx. 0.5mm). In consideration of this, the line
alignment is to be adjusted.
View from directly above
View from the side
Note
The desirable difference between the board transfer height is 0 through 0.1mm higher from
downstream machine.
Item
connection
Specification
No height difference or offsets that hinder
smooth board transfer
Distance between upstream/downstream
machine: 7 +/- 3mm
SI1906002E-001=YSP10 installation and adjustment procedures
41/120
For Service Engineers
Service Information