Yamaha YSP10 Service Information page 112

Save the measurements to desired destination under desired file name.
After the mask apertures are recognized, the Move Axis screen appears. Confirm
that solder marks are shot on the monitor and click the [OK] button.
1
Confirm that solder
marks are shot on the
monitor.
Confirmation message asking whether to save the measurements appears. The
measured offsets appear at the bottom of the screen. When mask camera offsets are
unacceptably large, confirmation message asking whether to adjust the mask camera offsets
appears. Depending on the measured results, follow the below steps:
SI1906002E-001=YSP10 installation and adjustment procedures
112/120
For Service Engineers
Service Information
Browse for a destination
folder to save the file.
Name the file.
2
Press [OK].