Yamaha YSP10 Service Information page 39

Measure the distance from the floor to the board transfer height (height of the
conveyor belt upper surface) with a metal tape measure or 1m bench rule. At this time, putting
a board or a line alignment jig on the conveyor facilitates the measuring procedures.
To adjust the distance from the floor to the board transfer height, raise or lower all 4 leveling bolts by the
same amounts to raise or lower the machine body.
Adjust the board transfer height to 900mm +/- 10mm and to the heights of the adjacent machines which
are to be done the line alignment by rotating the machine leveling bolts.
Board transfer height (distance from the floor to the
Measure with a
board on the
conveyor.
Item
conveyor belt upper surface)
SI1906002E-001=YSP10 installation and adjustment procedures
39/120
For Service Engineers
Service Information
Allowable range
900 +/- 10mm
Metal tape measure
Measure the height of the
board lower surface (conveyor
belt upper surface).