Yamaha YSP10 Service Information page 76

Check that the [Measured] values (X and Y) of [Standard] are within acceptable
range.
When the values are within range, fill in the check sheet with the values and finish without saving data.
When the values are out of range, save the data and redo from step 4.
Standard 2
Values are within range.
Press the [No] button and finish.
Check that the [Measured] values (X and Y) of [Standard] are within acceptable
range.
When the values are within range, fill in the check sheet with the values and finish without saving data.
When the values are out of range, save the data and redo. The values are out of range then, redo from
"13.7 13.7Adjust the R-axis initial positions".
Standard (of Force Point)
Standard (of Force Point) 2
Values shall be within range.
Values are out of range.
Press the [Yes] button and redo from step
4
SI1906002E-001=YSP10 installation and adjustment procedures
76/120
For Service Engineers
Service Information
Item Acceptable range
+/- 0.0003 or below
+/- 0.01 or below