Adjustments After Installing Ysp10; Workflow - Yamaha YSP10 Service Information

13. Adjustments after installing YSP10

13.1. Workflow

Check "Motor reference" values (P67)
Adjust the Dual drive offset (P69)
Adjust the R-axis initial positions (P71)
Adjust the R-axis linearity (P75)
Check and adjust the PCB transfer positions (Y and Z) (P77)
Adjust camera scales and positions (P90)
Adjust print feedback (P102)
Note
Normally the camera lighting conditions adjustment is not necessary for new installations.
However, if a mark recognition error occurs during adjustment and is not improved after
implementation of mark adjust, then perform the camera lighting conditions adjustment.
Adjust camera lighting conditions (P81)
SI1906002E-001=YSP10 installation and adjustment procedures
62/120
For Service Engineers
Service Information