Adjustments; Traction Bail Proximity Sensor - Toro Greensmaster eFlex 1021 Service Manual

Adjustments

Traction Bail Proximity Sensor

Adjusting the Traction Bail Proximity Sensor
Electrical System: Adjustments
g349622
1. Clutch bail link
2. Proximity sensor
1. Ensure that the cutting-unit-drive lever is in the D
machine on a level surface, release the clutch bail, engage the service and
parking brake, rotate the key switch to O
the Operator's Manual.
2. Disconnect the battery pack; refer to
Lithium Battery Pack (page
3. Remove the bolts and washers that secures the control cover to the handle
assembly. Remove the control cover from the machine.
4. Get access to the proximity sensor. Pull up and release the traction bail.
5. When the bail is open, adjust the proximity sensor gap to 2.3 to 3.8 mm
(0.09 to 0.15 in).
6. If the clearance is incorrect, loosen the proximity sensor jam nuts and adjust
the clearance.
7. After achieving the required clearance, torque tighten the proximity sensor
jam nuts to 18.3 to 22.3 N·m (13.5 to 16.5 ft-lb).
8. Install the control cover to the handle assembly and secure with bolts and
washers.
9. Connect the battery pack; refer to
Battery Pack (page
Figure 47
3. Jam nuts
FF
Disconnecting and Connecting the
5–3).
Disconnecting and Connecting the Lithium
5–3).
Page 5–20
position, park the
ISENGAGE
, and remove the key; refer to
Greensmaster
20248SL Rev C
® eFlex 1021