Idler Plate - Toro Greensmaster eFlex 1021 Service Manual

Idler Plate

g395810
1. Bushing
2. Idler plate
3. Flange nut
4. Spring pin (idler plate)—threaded
(with a 2-lug groomer gearbox)
5. Shoulder screw—threaded (with a
single-lug groomer gearbox)
Removing the Idler Assembly
Universal Groomer (Optional): Service and Repairs
6. Adjuster pin (with a 2-lug groomer
gearbox)
7. Cotter pin (with a 2-lug groomer
gearbox)
8. Spring pin (idler plate)—cross drilled
(with a single-lug groomer gearbox)
9. Bearing shield
10. Bearing
Note: The groomer idler plate is located at the opposite side of the groomer
gearbox.
Note: Early universal groomers used 2 non-adjustable compression springs on
eye bolts for the 2-lug gearbox and idler plate. The single-lug gearbox and idler
plate assemblies are the current groomer drive configuration, and use shim
washers to preload the springs; refer to
1. Remove the reel drive from the cutting unit; refer to
Assembly (page 4–7).
2. Remove the groomer reel assembly; refer to
(page 8–19).
3. Remove the eye bolt of the groomer adjuster from the idler plate as follows:
Figure 130
11.
12.
13.
Figure
Page 8–16
Retainer
Shaft
Shield
130.
Removing the Reel Drive
Removing the Groomer Reel
Greensmaster
20248SL Rev C
® eFlex 1021