Toro Greensmaster eFlex 1021 Service Manual page 189

Inspecting the Reel Assembly (continued)
Installing the Reel Assembly
Greensmaster ® eFlex 1021
20248SL Rev C
equivalent) to the threads of the spline adapter and the internal threads of
the LH reel nut prior to installation.
If installing a new spline adapter with factory applied thread locking
compound (patch lock): Remove any residual thread locking compound
from the internal threads of the LH reel nut.
E. Use a reel nut from a current riding Greensmaster cutting unit to install
the spline adapter. Tighten the spline adapter from 43 to 51.5 N·m (32
to 38 ft-lb).
7. Install the reel nuts finger tight.
1. Position the cutting unit on a flat work area.
Contact with the reel, bedknife or other cutting unit parts can result
in personal injury. Use heavy gloves when installing the cutting reel.
2. Apply a thin coat of grease to the outside of the cutting reel bearings and
carefully slide the cutting reel assembly into the right side plate. Make sure
that the reel bearing is fully seated in the RH side plate, and that the reel nut
on the left (exposed) end of the cutting reel has a black finish.
3. If removed, install the grass shield (14) to the crossmember (13) and secure
with the three bolts (15).
4. Place the flat wire spring into bearing bore of LH side plate and carefully
slide the left side plate onto the cutting reel assembly as far as possible.
5. Install the four shoulder bolts (3) that secure the RH and LH side plates (4
and 21) to the crossmember (13). Tighten the shoulder bolts (3) from 24 to
27 N∙m (210 to 240 in-lb).
6. Install the rear roller; refer to
7. Install the front roller; refer to
8. Install the bedbar assembly; refer to
9. If loosened during cutting reel service, tighten the RH reel nut and the LH
reel nut.
CAUTION
Installing the Rear Roller (page
Installing the Front Roller (page
Installing the Bedbar (page
Page 7–23
7–28).
7–27).
7–8).
DPA Cutting Units: Service and Repairs