Toro Greensmaster eFlex 1021 Service Manual page 186

Removing the Reel Assembly (continued)
DPA Cutting Units: Service and Repairs
To avoid grinding the reel, do not contact the cutting edge of
any blade with the pry bar as this may damage the cutting edge
and/or cause a high blade.
C. Move the pry bar against the weld side of the reel support plate closest to
the reel nut being removed.
The LH reel nut (with drive shaft) on the left end of the cutting
reel has left- hand threads. The reel nut on the right end of the
cutting reel has right- hand threads.
D. Rest the handle of the pry bar against the front roller and loosen the
reel nut.
E. Position the pry bar in the same manner on the opposite end of the reel
and loosen the remaining reel nut.
F. Tip the cutting unit back onto its roller.
8. Remove the bedbar; refer to
9. Remove the front roller; refer to
10. Remove the rear roller; refer to
11. Support the cutting reel to prevent it from shifting or falling and remove the 2
socket head screws (3) that secure the LH side plate (4) to the crossmember
(13).
12. Remove the 2 socket head screws (3) that secure the RH side plate (21) to
the crossmember (13).
13. Remove the crossmember (13) from the reel assembly (19).
14. If necessary, remove the three bolts (15) that secures the grass shield (14) to
the crossmember (13). Remove the grass shield (14) from the crossmember
(13).
15. Carefully slide the cutting reel assembly (with seals, bearings, and reel nuts)
from the side plates. Retrieve the flat wire spring from the reel bearing bore
of the left side plate.
16. Thoroughly clean any grease and corrosion from the reel bearing bores in
the side plates.
17. Inspect the remaining cutting unit components for corrosion, wear, or damage
and replace the components as necessary.
IMPORTANT
IMPORTANT
Removing the Bedbar (page
Removing the Front Roller (page
Removing the Rear Roller (page
Page 7–20
7–7).
7–27).
7–28).
Greensmaster ® eFlex 1021
20248SL Rev C