Toro Greensmaster eFlex 1021 Service Manual page 71

Removing the Transmission Gear Box Assembly
Greensmaster ® eFlex 1021
20248SL Rev C
Note: Refer to Figure 24
1. Ensure that the cutting-unit-drive lever is in the D
machine on a level surface, release the clutch bail, engage the service and
parking brake, rotate the key switch to O
the Operator's Manual.
2. Disconnect the battery pack; refer to
Lithium Battery Pack (page
3. Disconnect the brake cable; refer to
4. Disconnect the reel cable; refer to
5. Slide the collar lock (15) into the coupler shaft groove (13).
6. Slide the hex tube (16) to the coupler shaft (13) and disconnect the cutting
unit from the transmission gear box assembly.
7. Remove the nuts (4), washers (3) and truss screws (1) that secures the
splined couplers (2) to the drive shaft (5). Remove the splined couplers
from the drive shaft.
8. Remove the socket head screw (19) that secures the motor adaptor (18) and
transmission gear box assembly (10) to the frame assembly (6).
9. Remove the two flange head bolts (9) that secures the transmission gear box
assembly (10) to the frame assembly (6). Remove the transmission gear box
assembly with electric motor (22) from the frame assembly (6).
10. Remove the two socket head screws (19) that secures the motor adaptor
(18) to the transmission gear box assembly (10). Remove the motor adaptor
(18) and electric motor (22) from the transmission gear box assembly.
during this procedure.
FF
Disconnecting and Connecting the
5–3).
Removing the Brake Cable (page
Removing the Reel Cable (page
Page 4–23 Traction and Reel Drive Systems: Service and Repairs
position, park the
ISENGAGE
, and remove the key; refer to
6–4).
6–7).