Toro Greensmaster eFlex 1021 Service Manual page 54

Removing the Reel Drive Belt (continued)
Installing the Reel Drive Belt
Traction and Reel Drive Systems: Service and Repairs
4. Remove and inspect the reel drive gasket (5) from the reel drive housing (1).
Replace the reel drive gasket (5) if it is worn or damaged.
5. Loosen the nut securing carriage bolt (4) and the idler arm (3), and rotate the
arm to remove tension from the belt (2).
6. Remove the belt (2) from the pulleys.
1. Ensure that the nut and carriage bolt (4) are loose enough to freely move
the idler arm (3).
2. Place the new drive belt (2) over the pulleys.
3. Adjust the reel belt tension; refer to
4. Align the reel drive gasket (5) to the reel drive housing (1), and install the reel
drive cover (6) to the housing with the 4 socket head screws (7).
5. Initially torque the socket head screws to 1.7 to 4.5 N∙m (15 to 40 in-lb).
Then using an alternating pattern torque the socket head screws to 9.6 to
10.7 N∙m (85 to 95 in-lb).
6. Connect the battery pack; refer to
Battery Pack (page
Adjusting the Reel Drive Belt (page
Disconnecting and Connecting the Lithium
5–3).
Page 4–6
4–3).
Greensmaster ® eFlex 1021
20248SL Rev C