Toro Greensmaster eFlex 1021 Service Manual page 143

Removing the Brake Cable (continued)
Installing the Brake Cable
Greensmaster ® eFlex 1021
20248SL Rev C
g336873
1. Retaining ring
2. Cable eyelet
3. Remove the brake cable (item 5 in
the transmission gear box assembly as follows:
A. Loosen the front cable jam nut (4) that secures the brake cable to the
casting slot on the transmission gear box assembly. Remove the brake
cable from the slot.
B. Remove the retaining ring (1) that secures the cable eyelet (2) to the
brake lever (3) on the transmission gear box assembly.
C. Remove the brake cable eyelet (2) from the brake lever (3).
4. Remove the control cover and lower cover from the handle assembly to allow
access to upper end of the brake cable.
5. Remove the brake cable (item 9 in
as follows:
A. Loosen the lower brake cable jam nut (8) that secures the brake cable
(9) to the upper receiver weldment (4). Slide the brake cable from the
upper receiver weldment.
B. Remove the brake cable spring (7) from the spring anchor on the brake
lever assembly (3). Note the orientation of the brake cable spring hook
on the brake lever assembly for assembly purpose.
6. Remove the brake cable (9) from the machine.
1. Secure the brake cable (9) to the brake lever assembly as follows:
A. Install the cable spring (7) to the spring anchor on the brake lever
assembly (3).
B. Slide the brake cable into the shift mount bracket slot. Ensure that the jam
nut (8), flat washer and lock washer are both sides of the bracket. Adjust
the jam nuts so that equal amount of cable threads are visible above and
below jam nuts. Leave jam nuts snug until final cable adjustment.
2. Route the brake cable (9) to the transmission gear box assembly and install
the brake cable to the transmission gear box assembly as follows:
A. Install the brake cable eyelet (2) onto the brake lever (3) on transmission
gear box assembly and secure with a snap ring (1).
B. Position the brake cable (5) to the casting slot of the transmission gear
box assembly with a jam nut (4), flat washer and lock washer on each
Figure 79
3. Brake lever
4. Jam nut
Figure 79) from the brake lever shaft on
Figure 78) from the brake lever assembly
Page 6–5 Controls, Wheels, and Accessories : Service and Repairs
5. Brake cable