Toro Greensmaster eFlex 1021 Service Manual page 205

Removing the Gearbox Assembly (continued)
Greensmaster ® eFlex 1021
20248SL Rev C
• Machines with a 2-Lug Groomer Gearbox: remove the cotter pin and
adjuster pin from the eye bolt and gearbox-cover lugs. Discard the cotter
pin.
You must use a 6-point socket with a heavy wall to remove the
gearbox from the reel. Do not use an impact wrench. A groomer
gearbox installed at the right side of the cutting unit use a right hand
thread; turn the drive shaft counterclockwise to remove the gearbox.
11. Use a heavy wall, 6 point socket and breaker bar at the outboard end of
the groomer gearbox drive shaft, and rotate the socket counterclockwise to
loosen and remove the gearbox driveshaft from the reel shaft.
12. If the hex head on the end of the drive shaft is damaged during removal,
perform the following steps:
A. Rotate the cutting unit as shown in
IMPORTANT
Figure
Page 8–7 Universal Groomer (Optional): Service and Repairs
123.