Rail Kit Wheels (Optional) - Toro Greensmaster eFlex 1021 Service Manual

Rail Kit Wheels (Optional)

Removing the Rail Kit Wheel
Installing the Rail Kit Wheel
Controls, Wheels, and Accessories : Service and Repairs
g261683
1. Wheel hex shaft
2. Wheel clip
1. Ensure that the cutting-unit-drive lever is in the D
machine on a level surface, release the clutch bail, engage the service and
parking brake, rotate the key switch to O
the Operator's Manual.
2. Support the machine onto the kickstand.
3. Remove the wheel clip, and remove the rail kit wheel from the wheel hex
shaft on each side.
4. If necessary, install the transport wheels; refer to
Wheel (page 6–25).
1. Ensure that the machine is parked on a level surface.
2. Support the machine onto the kickstand.
3. If installed, remove the transport wheels; refer to
Wheel (page 6–23).
4. Slide the rail kit wheel onto the wheel hex shaft and secure the wheel with
a wheel clip.
Figure 93
3. Rail kit wheel
, and remove the key; refer to
FF
Page 6–26
position, park the
ISENGAGE
Installing the Transport
Removing the Transport
Greensmaster ® eFlex 1021
20248SL Rev C