Dell PowerVault 124T DLT VS160 User Manual page 5

Installing the Autoloader: Dell PowerVault 124T DLT VS160 Autoloader User's Guide
Weight 14.1 kg (31 lb) unloaded
17.2 kg (38 lb) loaded (2 magazines, 16 cartridges)
Air Quality Minimize sources of particulate contamination. Avoid areas near frequently used doors and walkways,
cooling or exhaust vents, stacks of supplies that collect dust, printers, and smoke-filled rooms. Avoid
placing on or near the floor, or in carpeted rooms.
Humidity 20–80% RH (noncondensing)
Clearance
Back: Minimum of 43.2 cm (17 in)
Front: Minimum of 68.6 cm (27 in)
Sides: Minimum of 5.08 cm (2 in)
UL Requirements
Elevated
When installed in a closed or multi-unit rack assembly, the operating ambient temperature of the rack
Operating environment may be greater than the room ambient. You must install the equipment in an
Ambient environment compatible with the manufacturer's maximum recommended ambient temperature.
Temperature
Reduced Air Installation of the equipment in a rack should be such that the amount of air flow required for safe
Flow
operation of the equipment is not compromised.
Mechanical
Mounting of the equipment in a rack should be such that a hazardous condition is not achieved due to
Loading uneven mechanical loading.
Overloading
Consideration should be given to the connection of the equipment to the supply circuit and the effect
the Circuit that overloading of circuits might have on overcurrent protection and supply wiring. Appropriate
consideration of equipment nameplate ratings should be used when addressing the concern.
Reliable Reliable grounding of rack-mounted equipment should be maintained. Particular attention should be
Grounding
given to supply connections other than direct connections to the branch circuit, such as use of power
strips.
Bar Code Reader
Your autoloader is equipped with a bar code reader. The bar code reader is enclosed within the body of the autoloader and
automatically scans each cartridge in the magazine upon power up, after a reset, after an import or export, or when a re-
inventory command is issued (see
available through SCSI and the Remote Management Unit to the computer's operating system or backup application upon
request. The barcode reader can be disabled through the operator control panel or the web user interface. This feature allows
faster initialization of the unit if non-bar code labels or no lables are used on the cartridges.
If utilizing the bar code reader, you must insert bar code labels into the slide-in slot on the front of each cartridge. The labels
file:///T|/htdocs/stor-sys/124T/en/124tvs16/install.html[12/5/2012 10:25:55 AM]
NOTICE: Excessive dust and debris can damage tapes and tape drives.
"Running an Inventory"). The information from each label is stored in memory and