Dell PowerVault 124T DLT VS160 User Manual page 67

Troubleshooting: Dell PowerVault 124T DLT VS160 Autoloader User's Guide
Drive TAflag[34]
Download Fail
TapeAlert Log Entry:
0000000040000000
Drive TAflag[35]
Drive Humidity
TapeAlert Log Entry:
0000000020000000
Drive TAflag[36]
Drive Temperature
TapeAlert Log Entry:
0000000010000000
Drive TAflag[37]
Drive Voltage
TapeAlert Log Entry:
0000000008000000
Drive TAflag[38]
Predictive Failure
TapeAlert Log Entry:
0000000004000000
Drive TAflag[39]
Diagnostics Required
TapeAlert Log Entry:
0000000002000000
Drive TAflag[50] Lost
Statistics
TapeAlert Log Entry:
0000000000004000
Drive TAflag[51]
Tape Directory
Invalid at Unload
TapeAlert Log Entry:
0000000000002000
Drive TAflag[52]
Tape System Area
Write Failure
TapeAlert Log Entry:
file:///T|/htdocs/stor-sys/124T/en/124tvs16/trouble.htm[12/5/2012 10:26:08 AM]
because you have tried to use the
incorrect firmware for this tape drive.
Environmental conditions inside the
tape drive are outside the specified
humidity range.
Environmental conditions inside the
tape drive are outside the specified
temperature range.
The voltage supply to the tape drive
is outside the specified range.
A hardware failure of the tape drive
is predicted.
The tape drive may have a hardware
fault
Media statistics have been lost at
some time in the past.
The tape directory on the tape
cartridge just unloaded has been
corrupted. File search performance
will be degraded.
The tape just unloaded could not
write its system area successfully.
failed.
Drive humidity limits
exceeded.
Cooling problem.
Drive voltage limits
exceeded.
Predictive failure of drive
hardware.
The drive may have a
hardware fault that may
be identified by extended
diagnostics (i.e., SEND
DIAGNOSTIC command).
Drive or library powered
on with tape loaded
Error preventing the tape
directory being updated
on unload.
Write errors while writing
the system area on
unload.
try again.
Run extended diagnostics
to verify and diagnose the
problem.
Check the tape drive user's
manual for device specific
instructions on running
extended diagnostic tests.
Clean drive.
Retry operation.
The tape directory can be rebuilt
by reading all the data.
Copy data to another tape
cartridge.
Discard the old cartridge.