Dell PowerVault 124T DLT VS160 User Manual page 66

Troubleshooting: Dell PowerVault 124T DLT VS160 Autoloader User's Guide
Drive TAflag[25]
Dual port Interface
Error
TapeAlert Log Entry:
0000008000000000
Drive TAflag[26]
Cooling Fan Failure
TapeAlert Log Entry:
0000004000000000
Drive TAflag[27]
Power Supply Failure
TapeAlert Log Entry:
0000002000000000
Drive TAflag[28]
Power Consumption
TapeAlert Log Entry:
0000001000000000
Drive TAflag[29]
Drive Maintenance
TapeAlert Log Entry:
0000000800000000
Drive TAflag[30]
Hardware A
TapeAlert Log Entry:
0000000400000000
Drive TAflag[31]
Hardware B
TapeAlert Log Entry:
0000000200000000
Drive TAflag[32]
Interface
TapeAlert Log Entry:
0000000100000000
Drive TAflag[33]
Eject Media
TapeAlert Log Entry:
0000000080000000
file:///T|/htdocs/stor-sys/124T/en/124tvs16/trouble.htm[12/5/2012 10:26:08 AM]
A redundant interface port on the
tape drive has failed.
A tape drive cooling fan has failed.
A redundant power supply has failed
inside the tape drive enclosure.
The tape drive power consumption is
outside the specified range.
Preventive maintenance of the tape
drive is required.
The tape drive has a hardware fault.
The tape drive has a hardware fault.
The tape drive has a problem with
the application client interface.
The operation has failed.
The firmware download has failed
Failure of one interface
port in a dual-port
configuration (i.e., Fibre
Channel).
Fan failure inside tape
drive mechanism or tape
drive enclosure.
Redundant PSU failure
inside the tape drive
enclosure or rack
subsystem.
Power consumption of
the tape drive is outside
specified range.
The drive requires
preventative
maintenance (not
cleaning).
The drive has a hardware
fault that requires reset
to recover.
The drive has a hardware
fault that is not
read/write related or
requires a power cycle to
recover.
The drive has identified
an interface fault.
Error recovery action
Firmware download
Check the enclosure user's manual
for instructions on replacing the
failed power supply.
Check the tape drive user's
manual for device specific
preventive maintenance tasks.
Eject the tape.
Reset the drive.
Restart the operation.
Power cycle the tape drive.
Restart the operation.
Check the SCSI interface
cables, terminator, and all
connections.
Restart the operation.
Eject the tape or magazine.
Insert the tape or magazine
again.
Restart the operation.
Obtain the correct firmware and