Dell PowerVault 124T DLT VS160 User Manual page 60

Troubleshooting: Dell PowerVault 124T DLT VS160 Autoloader User's Guide
F6 Barcode No Read
F7 Barcode Mismatch Error
F8 Barcode Duplicate Label
Error
Diagnostic Error Types
F9 Diagnostic Test Failure
FA Diagnostic Error, Drive
Reporting Write Protect
FB Diagnostic Error, Cleaning
Tape Inserted
FC Diagnostic Load Tape
Prompt
FD Diagnostic Unknown Tape
Format
FE Diagnostic Invalid
Configuration
file:///T|/htdocs/stor-sys/124T/en/124tvs16/trouble.htm[12/5/2012 10:26:08 AM]
If problems recur with the original cartridge or label, replace.
If all previous steps fail, contact support.dell.com.
Barcode label not present.
Apply valid barcode label to cartridge, or disable the barcode reader
through the Operator Control Panel or Remote Management Unit.
Power cycle the autoloader.
Run the Random Moves test from either the Remote Management Unit
(RMU) or the Operator Control Panel (OCP).
Note: The Random Moves test requires a minimum of two cartridges
present within the autoloader.
If all previous steps fail, contact support.dell.com.
Duplicate barcode.
Power cycle the autoloader.
Re-run the failing diagnostic test.
If all previous steps fail, contact support.dell.com.
Verify that valid, not data protected media is present for test.
Run the Random Moves test from either the Remote Management Unit
(RMU) or the Operator Control Panel (OCP).
Note: The Random Moves test requires a minimum of two cartridges
present within the autoloader.
If all previous steps fail, contact support.dell.com.
This is a prompt to manually load a cartridge as required for test.
Verify that valid, not data protected media is present for test.
Run the Random Moves test from either the Remote Management Unit
(RMU) or the Operator Control Panel (OCP).
Note: The Random Moves test requires a minimum of two cartridges
present within the autoloader.
If all previous steps fail, contact support.dell.com.
This is an indication that a minimum of two pieces of media are required for test.
Insure at least two cartridges are present in the autoloader and re-run the
failed test.