Dell PowerVault 124T DLT VS160 User Manual page 64

Troubleshooting: Dell PowerVault 124T DLT VS160 Autoloader User's Guide
TapeAlert Log Entry:
0080000000000000
Drive TAflag[10] No
Removal
TapeAlert Log Entry:
0040000000000000
Drive TAflag[11]
Cleaning Media
TapeAlert Log Entry:
0020000000000000
Drive TAflag[12]
Unsupported Format
TapeAlert Log Entry:
0010000000000000
Drive TAflag[13]
Recoverable
Mechanical Cartridge
Failure
TapeAlert Log Entry:
0008000000000000
Drive TAflag[14]
Unrecoverable
Mechanical Cartridge
Failure
TapeAlert Log Entry:
0004000000000000
Drive TAflag[15]
Memory Chip In
Cartridge Failure
TapeAlert Log Entry:
0002000000000000
Drive TAflag[16]
Forced Eject
TapeAlert Log Entry:
0001000000000000
Drive TAflag[17]
Read Only Format
TapeAlert Log Entry:
0000800000000000
Drive TAflag[18]
file:///T|/htdocs/stor-sys/124T/en/124tvs16/trouble.htm[12/5/2012 10:26:08 AM]
You cannot eject the cartridge
because the tape drive is in use. Wait
until the operation is complete before
ejecting the cartridge.
The tape in the drive is a cleaning
cartridge.
You have attempted to load a
cartridge of a type that is not
supported by this drive.
The operation has failed because the
tape in the drive has experienced a
mechanical failure.
The operation has failed because the
tape in the drive has experienced a
mechanical failure.
The memory in the tape cartridge has
failed, which reduces performance.
Do not use the cartridge for further
write operations.
The operation has failed because the
tape cartridge was manually de-
mounted while the tape drive was
actively writing or reading.
You have loaded a cartridge of a type
that is read-only in this drive. The
cartridge will appear as write
protected.
The tape directory on the tape
cartridge has been corrupted. File
Manual or software
unload attempted when
prevent media removal is
on.
Cleaning tape loaded into
drive.
Attempted load of
unsupported tape format.
(e.g., Unformatted Type
IV media in a VS160
drive.)
Tape snapped/cut or
other cartridge
mechanical failure in the
drive where medium can
be de-mounted.
Tape snapped/cut or
other cartridge
mechanical failure in the
drive where medium
cannot be de-mounted.
Memory chip failed in
cartridge.
Manual forced eject while
drive actively writing or
reading.
Media loaded that is
read-only format.
The tape drive powered
down with tape loaded,
Check in the RMU if the
Software Lock is set.
Perform an unlock using the
Backup Application.
Use tape format correct for the
drive type.
Discard the old tape. Restart the
operation with a different tape.
Discard the old tape. Restart the
operation with a different tape.
Replace cartridge.
Retry operation using the same
media.
Check write protect tab on
cartridge.
Retry operation with same