Simultaneous Recording During Machining Of The Workpiece - Siemens SINUMERIK 840D sl Universal Operating Manual
Hide thumbs
Also See for SINUMERIK 840D sl Universal:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
8.4
Simultaneous recording during machining of the workpiece
If the view of the work space is blocked by coolant, for example, while the workpiece is being
machined, you can also track the program execution on the screen.
Procedure
Note
• If you switch on simultaneous recording after the blank information has already been
processed in the program, only traversing paths and tool are displayed.
• If you switch off simultaneous recording during machining and then switch on the function
again at a later time, the traversing paths generated in the meantime will not be displayed.
Universal
Operating Manual, 07/2021, 6FC5398-6AP40-6BA4
8.4 Simultaneous recording during machining of the workpiece
Software option
You require the option "Simultaneous recording (real-time simulation)" for simultane‐
ous recording.
1.
Load a program in the "AUTO" mode.
2.
Press the "Sim. rec." softkey.
3.
Press the <CYCLE START> key.
The machining of the workpiece is started and graphically displayed on
the screen.
4.
Press the "Sim. rec." softkey again to stop the recording.
Simulating machining
223
Advertisement
Table of Contents
