Selecting A Block; Deleting A Block - Siemens SINUMERIK 840D sl Universal Operating Manual
Hide thumbs
Also See for SINUMERIK 840D sl Universal:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Procedure
14.3.3
Selecting a block
You have the option of setting the interrupt pointer to the current cursor position. The next time
the program is started, processing will resume from this point.
With teach-in, you can also change program areas that have already been executed. This
automatically disables program processing.
You must press reset or select a block to resume the program.
Procedure
14.3.4
Deleting a block
In teach-in mode, you can delete both a teach-in block and a program block entirely.
Universal
Operating Manual, 07/2021, 6FC5398-6AP40-6BA4
1.
Teach-in mode is active.
2.
Select the program block to be edited.
3.
Press the relevant softkey "Teach position, "Rap. tra. G0", "Straight line
G1", or "Circ. interm. pos." CIP", and "Circ. end pos. CIP".
The relevant windows with the input fields are displayed.
4.
Traverse the axes to the desired position and press the "Accept" softkey.
The program block is taught with the modified values.
- OR -
Press the "Cancel" softkey to cancel the changes.
1.
Teach-in mode is active.
2.
Place the cursor on the desired program block.
3.
Press the "Block selection" softkey.
Teaching in a program
14.3 Processing a program
381
Advertisement
Table of Contents
