Opening Tool Data; Checking The Loading - Siemens SINUMERIK 840D sl Universal Operating Manual

13.18.2

Opening tool data

Introduction
The recorded tool data are stored in a TTD file (Tool Time Data). The TTD file is always located with
the associated part program and contains the following information:
• Tool data
• Magazine assignment
• Operating time, idle time, tool number, D number, ID per block
You can open the TTD file with the "Check loading" softkey.
Note
You can only open TTD files that are assigned to the active channel.
Opening a TTD file
Note
If the TTD file is older than the associated part program, a message informs you of this.
13.18.3

Checking the loading

When you click the "Check loading" softkey, the "Check loading" window opens.
The view in the "Check loading" window is divided into the following sections:
• Missing tools: tool not available
• Tools still to be loaded: tool available but not loaded
Universal
Operating Manual, 07/2021, 6FC5398-6AP40-6BA4
1. Select the "Program Manager" operating area.
2. Under part programs, open the corresponding file with the extension *.
TTD.
The "Tools for program" window opens.
The file contents are displayed in the form of a tool list.
13.18 Recording tools and determining the demand
Managing programs
367