View; Side View - Siemens SINUMERIK 840D sl Universal Operating Manual

8.5.3 3D view
Displaying the 3D view
Changing the display
You can increase or decrease the size of the simulation graphic, move it, turn it, or change the
segment.
Displaying and moving cutting planes
You can display and move cutting planes X, Y, and Z.
See also
Enlarging or reducing the graphical representation (Page 230)
Panning a graphical representation (Page 231)
Rotating the graphical representation (Page 231)
Modifying the viewport (Page 232)
Defining cutting planes (Page 232)
8.5.4

Side view

Displaying further side views
Universal
Operating Manual, 07/2021, 6FC5398-6AP40-6BA4
1. Simultaneous recording or the simulation is started.
2. Press the "Other views" and "3D view" softkeys.
Software option
You require the option "3D simulation (finished part)" for the simulation.
1. Simultaneous recording or the simulation is started.
2. Press the "Other views" softkey.
3. Press the "From front" softkey if you wish to view the workpiece from the
front.
- OR -
Press the "From rear" softkey if you wish to view the workpiece from the
rear.
Simulating machining
8.5 Different views of the workpiece
225