Alarm Class - Siemens SiPass integrated Reference Manual

Alarm Class

4
4 Alarm Class
12 | 66
This section lists all of the possible states and their descriptions for each Alarm
Alarm Class
Type in the
When creating an alarm class, you can define alarm states. For example, if you
were to create an alarm class for output points (in particular, doors with locks), you
could create two states for that class. The first state would be a restore (normal)
state when the door is locked and the second state would be an alarm state when
the door is unlocked. The event that triggers the state (door locked or unlocked) is
known as the status.
Type
Access Daily code
Low battery detected
Good access with time
stamp
Access granted to Anti-
Passback Area
Card activates APB area
either ON
Card activates APB area
either OFF
Card activates floor
Card did not activate a
floor
Door Time Schedule
Active
Door Free
Door Secured
Tamper inactive on reader The tamper input on a reader interface
Reader online
Reader timeout
Badge collision on reader
Access granted on reader
Door (Latch) locked
No Additional Access
Mode Set
PIN as Card Mode Set
Daily Code mode set
dialog.
Status
The correct Daily Code was entered at a
keypad.
A card has been used that has a low HFPU
battery and needs to be replaced, as soon
as possible.
A valid card was read at a card reader.
A cardholder has successfully entered an
Anti-Passback area with a valid card.
A card was used to secure an area.
A card was used to unsecure an area.
A card was used at a card reader to secure a
floor.
A card was used, unsuccessfully, at a card
reader to secure a floor.
A door has reverted to normal Time
Schedule control after being manipulated by
a manual command or Event Task.
The door latch is open and the door frame
monitor is disabled.
The door latch is secured and the door frame
monitor is enabled.
module is inactive.
A reader has come online.
A reader has timed out after a card was
badged and PIN entry was expected.
Not supported.
Access has been granted at an access point.
The door latch is secured.
The reader has been set to No Additional
Access mode.
The reader has been set to PIN as Card
mode.
The reader has been set to Daily Code
mode.
Description
A6V11144326