Siemens SiPass integrated Reference Manual page 25

A6V11144326
Type Command
Set Mode "Card and
PIN"
Set Mode "Card Only" Sets the point's operation mode to "Card Only".
Set Mode "D.R. Card
and PIN"
Set Mode "D.R. Card
Only"
Set Mode "Disabled"
Set Mode "H.V. Card
and PIN"
Set Mode "H.V. Card
Only"
Set mode "No Dual
Custody"
Set mode
"Programmable
Authorization – Card
+ PIN"
Set mode
"Programmable
Authorization – Card
Only"
Set mode "Standard
Dual Custody"
Set mode
"Supervisory Dual
Custody"
Set Mode "V.O. Card
and PIN"
Set Mode "V.O. Card
Only"
Unblock Door
Unlock Door
Input Cancel Permanent
Action
Isolate
Pulse
Return to Time
Schedule Control
Secure (Enable)
Manual Override
Description
Sets the point's operation mode to "Card and PIN".
Sets the point's operation mode to "Delayed
Reporting Card and PIN".
Sets the point's operation mode to "Delayed
Reporting Card Only".
Sets the point's operation mode to "Disabled".
Sets the point's operation mode to "Host
Verification. Card and PIN".
Sets the point's operation mode to "Host
Verification Card Only".
Disables Dual Custody for the access point.
Sets the point's operation mode to "Programmable
Authorization – Card + PIN".
Sets the point's operation mode to "Programmable
Authorization – Card Only".
Set the access point to Standard Dual Custody
Mode.
Set the access point to Supervisory Dual Custody
Mode.
Sets the point's operation mode to "View Only.
Card and PIN".
Sets the point's operation mode to "View Only Card
Only".
Turns off the block door command. Returns the
door to its normal programmed mode of operation.
The door latch will be unlocked until the next "lock"
command is received.
Any current Permanent Command or Event Task,
or Access/Internal Action operating on the point will
be cancelled. The next Control State in the Control
State Queue will take effect.
External intrusion areas will ignore the state of
inputs that are isolated, for the purposes of arming.
This is only applicable for external intrusion input
points.
Sends a pulse command to the selected Input. This
is only applicable for Sintony input points of type
"Serial Coms Input"
The input point will return to normal Time Schedule
control.
Enables the input, if it is currently disabled, until the
next change in Time Schedule.
6
25 | 66