Siemens SiPass integrated Reference Manual page 44

Controller Event Tasks
8
Sources
44 | 66
Type State (trigger)
Host Verify Message An event task has been triggered when a
Host Verify Timeout
Message
Host Verify View
Only Message
No Entry
Passback Error
PIN Error
PIN Error Disabled
Point Disabled
Soft Anti-Passback
error
Soft Perimeter
Violation
Time Schedule
Violation
Timed Re-Entry
Error
Controller About to Reset
AC Power Fail
AC Power OK
Audit Trail Disabled
Description
request for Image Verification has been sent
from an access point to SiPass integrated.
An event task has been triggered when a card
has been badged at an image verification
access point, and the operator has not
responded within the defined Host Verify
Timeout.
An event task has been triggered when a view-
only image verification event has occurred at
an access point.
An event task is triggered if the access point is
set to "Delayed Reporting" mode and a valid
card has been badged at a reader, but the
door monitor has not registered passage
through the door.
An event task has been triggered when a card
has been badged out of sequence at an
access point configured for Global Anti-
Passback.
An event task has been triggered when an
incorrect PIN for that card number has been
entered at an access point.
An event task has been triggered when a card
has been voided after the cardholder has
made three consecutive incorrect PIN entries
in the facility.
An event task has been triggered when an
access point has been disabled.
An event task has been triggered when a soft
Anti-Passback error has occurred.
An event task has been triggered when a Soft
perimeter violation has occurred.
An event task has been triggered when a card
was rejected because it has access to this
door but not at the current time
An event task has been triggered when a
cardholder has attempted to re-enter an area
(set to Timed Re-Entry Anti-Passback mode)
before their permitted re-entry time.
ACC is about to reset.
An event task has been triggered when a
controller event task is triggered when the
mains power to the ACC fails.
An event task has been triggered when a
controller event task is triggered when the
mains power to the ACC has been restored.
An event task has been triggered when a
controller event task is triggered when Audit
Trail reporting from the ACC to the Server is
disabled.
A6V11144326