Siemens SiPass integrated Reference Manual page 36

Host event tasks
7
Targets / Commands
36 | 66
Target Command
Unblock Door
Request Access
Mode
Set mode "No Dual
Custody"
Set mode "Standard
Dual Custody"
Set mode
"Supervisory Dual
Custody"
Restore Access Mode
configuration
Set "No Additional
Access"
Set "PIN as Card"
additional access
mode
Set "Daily Code"
additional access
mode
Restore additional
access mode
Unlock Door, Override
Door Interlocking
Allow Access,
Override Door
Interlocking
Intrusion Control –
Enable
Intrusion Control –
Disable
Intrusion Control –
Restore Config
Set mode
"Authorization – Card
Only"
Set mode
"Authorization – Card
+ PIN"
Access Point Same as access
Group points
Actionable Not applicable
Report
Anti-Passback Forgive
Area
Forgive all
Description
Returns a blocked door to its normal
programmed mode of operation.
Request a current access mode.
Disables Dual Custody for the access point.
Sets the access point to Standard Dual Custody
Mode.
Sets the access point to Supervisory Dual
Custody Mode.
Restores the access mode that is stored in the
database.
Sets the additional access for the selected
access point to No Additional Access.
Sets the additional access for the selected
access point to PIN as Card.
Sets the additional access for the selected
access point to Daily Code.
Returns the access point to the normal additional
access operation mode defined in the
Components screen.
Unlocks the door and ignores any Door
Interlocking configuration.
Allows access and ignores any Door Interlocking
configuration.
Enable Intrusion Control on the selected access
point.
Disable Intrusion Control on the selected access
point.
Restore Intrusion Control to whatever is
configured.
Enables "Authorization – Card Only" operation at
an access point. Refer to Operational modes for
more information.
Enables "Authorization – Card + PIN" operation
at an access point. Refer to Operational modes
for more information.
See "Access Point"
Performs the default actions that were configured
for the report that appears in the Report field.
Forgives a single cardholder.
Enter the card number of the forgiven cardholder
into the Data field.
Forgives all cardholders currently in the area.
A6V11144326