Siemens SiPass integrated Reference Manual page 52

Controller Event Tasks
8
Commands
52 | 66
Type
Pulse
Set state to Alarm
Set state to Normal
Intrusion Arm intrusion area
Disarm intrusion area
Isolate input
Part Arm Intrusion Area
Part Arm B Intrusion
Area
Clear Sintony Intrusion
area alarm.
Output Point Unlock
Lock
Toggle
Slow Pulse
Fast Pulse
Single Pulse
Return to Time Schedule
Control
Command
Sends a pulse command to the selected
Input. This is only applicable for Sintony
input points of type "Serial Coms Input"
Set the input to state Alarm.
Set the input to state Normal.
Arms the specified intrusion area.
Disarms the specified intrusion area.
Isolates input points in alarm mode and
disables them within the specified intrusion
area so that it can be armed for intrusion.
Arm input points in an Intrusion area.
Arm input points B in an Intrusion area.
Sends command to Sintony panel to clear
the Sintony intrusion area alarm.
Unsecures the selected output point. Enter
the time for which you want the door to be
unlocked into the Duration field, using the
format HH:MM:SS.
Secures the selected output point. Enter
the time for which you want the door to be
locked into the Duration field, using the
format HH:MM:SS.
Reverses the current status of the output
point.
Causes the output point to emit a slow
pulse behaviour, depending on the point
type. For example, a strobe light attached
to a door controller would flash at a
relatively slow rate.
Enter the time for which you want the
output to slow pulse into the Duration field,
using the format HH:MM:SS.
Causes the output point to emit fast pulse
behaviour, depending on the point type.
For example, a siren attached to a door
controller would sound at rela-tively fast
repeated intervals.
Enter the time for which you want the
output to fast pulse into the Duration field,
using the format HH:MM:SS.
Causes the output point to emit a single
pulse, depending on the point type.
The output will return to normal Time
Schedule control.
Description
A6V11144326