Commands - Siemens SiPass integrated Reference Manual

8.2 Commands

A6V11144326
Controller event tasks allow you to perform a range of hardware-related tasks and
trigger host event tasks in response to events.
The following table lists the Types and Commands that can be selected when
defining an Effect for a Controller Event Task.
Type
Access Point Reader LED OFF
Reader LED blink
Unlock Latch
Lock Latch
Allow Access
Set Mode "Card Only"
Set Mode "Card and PIN" Enables Card and PIN operation at an
Set Mode "H. V. Card
Only"
Set Mode H. V. "Card
and PIN"
Set Mode V. O. Card
Only
Set Mode V. O. "Card
and PIN"
Set Mode D. R. "Card
Only"
Set Mode D. R. "Card
and PIN"
Set Mode "Disabled"
Restore Access Mode
Command
Turns the Reader LEDs off. You can also
select the colour of the LED you want to
affect.
Blinks the specified Reader LED. You can
also select the colour of the LED you want
to affect.
Unlocks the door latch associated with the
specified reader.
Locks the latch controlled by the selected
reader.
Allows access at the door con-trolled by the
reader.
Enables Card Only operation at an access
point. Refer to Operational modes page 22
for more information.
access point. Refer to Operational modes
page 22 for more information.
Enables Host Verification Card Only
operation at an access point. Refer to
Operational modes page 22 for more
information.
Enables Host Verification Card and PIN
operation at an access point. Refer to
Operational modes page 22 for more
information.
Enables View Only Card Only operation at
an access point. Refer to Operational
modes page 22 for more information.
Enables View Only Card and PIN operation
at an access point. Refer to Operational
modes page 22 for more information.
Enables Delayed Reporting Card Only
operation at an access point. Refer to
Operational modes page 22 for more
information.
Enables Delayed Reporting Card and PIN
operation at an access point. Refer to
Operational modes page 22 for more
information.
Disables an access point. Refer to
Operational modes page 22 for more
information.
Restores the previous access mode at an
access point. Refer to Operational modes
page 22 for more information.
Controller Event Tasks
Commands
Description
49 | 66
8