Siemens SiPass integrated Reference Manual page 16

Alarm Class
4
16 | 66
Type
Image Normal
Verification
Privilege
Operator No IV privilege
Input Passback
Normal
Door closed
Fire override off
Battery OK
AC power back
Input closed
Input Enabled
Input Physically Enabled
at FLN device
Input tamper or fault
cleared
Sintony Input Sealed
Sintony Input Isolated
Alarm
Tamper
Door held
Door forced
Fire override on
Battery failed
Battery low
AC power failed
Status
The operator has privileges to allow or deny
entry based on visual identification of live
and database cardholder images.
The operator does not have privileges to
allow or deny entry based on visual
identification of live and database cardholder
images.
A passback button has been activated.
The input is normal.
The door is closed.
The fire override is disabled.
The unit's battery output voltage is above
11.5V.
The unit's AC power supply has been
restored. The unit will cease to draw power
from the battery backup.
The input has been closed.
The input has changed state and is now
enabled.
The Fire Override on the device has been
enabled physically.
The input tamper state has been cleared /
fixed.
The Sintony input is inactive and the input
area could be armed.
Overrides the Sintony Input Unsealed
therefore allows the area to be armed and
also disables the processing of this input in
the intrusion system.
The input is in alarm.
A monitored input or wire has changed state
and is either short or open circuit.
The door is being held open. (The door has
remained open after the latch time has
expired).
The door has been forced (opened without
gaining valid access).
The fire override has been enabled.
The unit's battery voltage has dropped below
11V. The battery circuit will be broken,
forcing a loss in communications. However,
the database memory is retained.
The unit's battery output voltage has
dropped below 11.5V.
The unit's AC power supply has failed. The
battery backup will be switched on
automatically.
Description
A6V11144326