Siemens SiPass integrated Reference Manual page 50

Controller Event Tasks
8
Commands
50 | 66
Type Command
Return to Time Schedule
Control
Cancel Permanent
Action
Reset Reader Tamper
Reader Buzzer on
Reader Buzzer Off
Block Door
Unblock Door
Set mode "No Dual
Custody"
Set mode "Standard Dual
Custody"
Set mode "Supervisory
Dual Custody"
Restore Dual Custody
Config Mode
Report Dual Custody
Config Mode
Set "No Additional
Access"
Set "Daily Code"
additional access mode
Set "PIN as Card"
additional access mode
Restore additional
access mode
Unlock Door, Override
Door Interlocking
Allow Access, Override
Door Interlocking
Intrusion Control –
Enable
Intrusion Control –
Disable
Intrusion Control –
Restore Config
Description
Returns the Target point to normal Time
Schedule control.
Any current Permanent Command or Event
Task, or Access/Internal Action operating
on the target will be cancelled. The next
Control State in the Control State Queue
will take effect.
Resets the reader tamper for the specified
reader. Only available for the Siemens
reader range.
Turns the buzzer for the specified reader
ON. Only available for the Siemens reader
range.
Turns the buzzer for the specified reader
OFF. Only available for the Siemens reader
range.
Blocks the door for the associated reader.
Unblocks the door for the specified reader,
the reader returns to its programmed mode
of operation.
Disables Dual Custody for the access
point.
Set the access point to Standard Dual
Custody Mode.
Set the access point to Supervisory Dual
Custody Mode.
Restores Dual Custody to the configured
mode.
Reports the configured Dual Custody
mode.
Set the additional access for the selected
access point to No Additional Access.
Set the additional access for the selected
access point to Daily Code.
Set the additional access for the selected
access point to PIN as Card.
Returns the access point to the normal
additional access operation mode defined
in the Components screen.
Unlocks the door and ignores any Door
Interlocking configuration.
Allows access and ignores any Door
Interlocking configuration.
Enable Intrusion Control on the selected
access point.
Disable Intrusion Control on the selected
access point.
Restore Intrusion Control to whatever is
configured.
A6V11144326