Siemens SiPass integrated Reference Manual page 17

A6V11144326
Type
Input tamper
Input open
Card limit reached
Passback tamper
Input Disabled
Input Faulty
Input Physically disabled
at FLN device
Sintony Input Unsealed
Intrusion Area Intrusion Area Armed
Normal
Arming Action Complete
Intrusion Area Part Armed The intrusion area has been part armed.
Intrusion Area Part Armed
B
Intrusion Area Disarmed
Alarm
Arming Failed
OPC Point Normal
Acked Alarm
Unacked Normal
Disabled
Alarm
Output Locked
Output Enabled
Unlocked
The output is not secure.
Output Open
Unit Communication back
Unit reset
Unit Tamper inactive
Power Returned
Status
The input or wiring has been tampered with.
The input is an open circuit.
The unit's card limit has been exceeded
A supervised passback input has detected a
tamper.
The input has been disabled.
The input is not recognised
The input has been physically disabled by
setting jumpers on the device.
The Sintony input is active and may prevent
the area from being armed (depending on
the configuration)
The intrusion area has been armed.
An intrusion area that was in an alarm state
has now returned to the normal state.
An attempt to arm a dependant intrusion
area was made. However, other areas
dependant on this area are still unarmed.
The SPC intrusion area has been part armed
B. (SPC only)
The intrusion area has been disarmed.
An armed intrusion area has been violated.
An attempt to arm an intrusion area has
failed.
The OPC Point is in a normal state.
The OPC Point is in alarm, but the alarm has
been acknowledged.
The OPC Point is in a normal state after an
alarm, but has not been acknowledged.
The OPC Point is disabled.
The OPC Point is in alarm.
The output is secure.
The output has been enabled.
The output is not secure.
The output has been disabled.
Output is in an open status
Communication between the unit and the
server is active.
A unit has been reset.
The tamper input on a unit is inactive
Power has been applied to the unit.
Alarm Class
4
Description
17 | 66