FusionModule2000 Smart Modular Data Center
Maintenance Guide
Figure 5-69 Removing a strip light
(1) Strip light terminal
Step 7 Install a new strip light.
Step 8 Install the new strip light by performing the preceding steps in reverse order.
Step 9 On the ECC800-Pro WebUI, choose Maintenance > Deployment Wizard >
Linkage Test > eLight Actuator Commissioning and click Test. The eLight strip
light is lit up in red, green, blue, and white in sequence for 3 seconds respectively,
and then turns off.
----End
5.4.24 Replacing an eLight Actuator
Impact on the System
The eLight strip light is off during replacement.
Preparations
●
●
Issue 02 (2022-07-30)
Tools: ESD gloves, Phillips screwdriver, step ladder, label, marker
Material: eLight actuator
Copyright © Huawei Digital Power Technologies Co., Ltd.
(2) Strip light extension cable
5 Parts Replacement
119