Fujitsu AJ 126LELDH Series Design & Technical Manual page 1001

• CN14 (Ch1) and CN15 (Ch2): Apply voltage terminal
When a power supply must be provided at the input device you want to connect, connect to CN14
(Ch1) and CN15 (Ch2).
1 Make the power supply DC 24 V. Select a power supply capacity with an ample sur-
* :
plus for the connected load.
2 Do not impress a voltage exceeding 24 V across pin 1-3.
* :
3 The allowable current is DC 5 mA or less. (Recommended: DC 5 mA)
* :
Provide a load resistance such that the current becomes DC 5 mA or less.
A twisted pair cable 0.33 mm
Input method
Edge
Pulse
4-2. Central remote controller (UTY-DCGZ)
*1
Power supply
DC 24 V
*3
*2
*3
CN14 (Ch1, White)
2
(22 AWG) should be used. (Maximum cable length: 25 m)
Terminal
CN14 (Ch1)
CN14 (Ch1)
CN15 (Ch2)
- (08-33) -
PCB
CN15 (Ch2, Black)
Input signal
"Emergency Stop"
Low → High
or "All on"
"Emergency Stop" reset
High → Low
or "All Off"
"Emergency Stop"
Low → High
or "All on"
"Emergency Stop" reset
Low → High
or "All Off"
Operation
4. Controller