Fujitsu AJ 126LELDH Series Design & Technical Manual page 894

7. To return to the 2-wire remote controller address selection screen, press the START/STOP
button. If setting has been completed, press FAN "
selection screen.
When returning to the 2-wire remote
controller address selection screen
RELATED LINKS
"Completion of setting mode"
"Function details" on page 07-108
¢ Setting up each indoor unit
Setting must be performed on each indoor unit by repeating following procedures.
• "Preparation" on page 07-96
• "Indoor unit function setting"
• "Completion of setting mode"
Indoor unit
01
¢ Resetting the power after setting up all indoor units
NOTES:
• If the reset is not performed, function cannot be read correctly.
• After all the functions have been set, the circuit breaker needs to be switched off for at least 2
minutes.
– After the 2 minutes has passed, power can be restored.
– The set function is stored in the PCB and will remain in memory even when the power of in-
door unit is turned off.
However setting function is effective after disconnecting the power supply and then recon-
necting it.
• Record the latest configuration of the indoor unit function setting on a label, and put the label on
the unit so it can be used for after-sales service operations.
2-6. Indoor unit (setting by UTY-RSR, UTY-RHR)
on page 07-37
on page 07-97
on page 07-37
Indoor unit Indoor unit
00 0 01 01 1 01 02 2
Simple remote
controller
" button to return to the Menu 2-F1 item
Setting completed and returning to
the Menu 2-F1 item selection screen
Indoor unit Indoor unit
01 13 0 01
Simple remote Simple remote
controller controller
- (07-98) -
Indoor unit
14 1 01 15 0
2. Function settings
/